More Console Stuff

 Here's where I'm at today on the console.  I can see this is going to take a while.  Lot of holes to cut and they gotta be pretty precise.

I got the hole cut for the shifter.  Did this first because alignment was critical.  Then got the cup holders cut and the phone holders.  Then cut the hole for the charger which can't be seen here and the usb connection to the EFI system is done.  

Now just need to do the radio, Lock button, and Seat Heater button.  Then cuts at the lower rear are for the seat belt strap.

After I finish the holes I have to do some fiberglassing to build supports for the shifter panel and figure out how to attach that.  I also have to make some kind of decorative thingy for the front of the shifter panel.  The stock console had all this stuff built in but that would have been too easy.  

I think I'll be all next week on this.

Oh, I also have to fiberglass in and fabricate some mounts to hold the comsole in place.